-
1, the absolute level of CNC lathe adjustment in the 0.04 / 1000mm range. CNC lathes for the instrument, in addition to horizontal and non-distorted to meet the requirements, but also should be adjusted linear guide to ensure that the linea
-
Machining a part on a small CNC lathe usually takes the following steps:
1) according to the processing of parts of the drawings and process plans, with the prescribed code and program format to write a single program, and record it on the
-
In the operation of CNC lathe machining center for knife is one of the most common operation of the project, but with updated technology in the NC system mostly adopts the automatic tool change way, the three most common way by the automati
-
1, the proposed instrument CNC lathe continuous operation up to 24h, if the continuous run time is too long will affect the electrical system and part of the mechanical life of the device, which will affect the accuracy of the machine.
-
-
1, small CNC lathe rigid enough
Such as the pallet trolley loosening, transmission imbalance caused by vibration.Of course, the instability of the lathe can also cause vibration, due to vibration caused by the workpiece surface roughness r
-
Cause and Solution of Dimension Accuracy of Shaft Type Workpiece
1, because the operator is not careful, test the child when the error, or dial wrong and improper use
Therefore, in the measurement, to carefully, the correct use of the dia
-
Standard configuration
1. Spindle unit,
2. System：GSK980,
3. Hydraulic chuck,
4 .Spindle servo drive,
5. 8 station hydraulic turret,
6. Hydraulic tailstock,
7. Automatic lubrication,
8. Cooling system.
-
Today, more and more CNC lathe manufacturers want to choose a good CNC lathe manufacturers, to understand his company profile is true, the company has a real technical elite in the town, the number of Tai'an machinery Su graduated in 1985 S
-
High-speed, high-precision machine tool development is the eternal goal. With the rapid development of science and technology, mechanical and electrical products to speed up the upgrading of the precision machining parts and surface quality
-
Knife selection knife is normal, is normal, that is not reverse locking. Indicating the normal worm drive, the initial electrical circuit as the problem. In the machine tool holder control electrical schematic diagram, found in reverse lock
-
CNC lathes, CNC lathes, hydraulic lathes, hydraulic station, manual chucks, hydraulic cards, hydraulic lathes, CNC lathes, CNC lathes, CNC lathes, CNC lathes, hydraulic lathes, Disk, the main electrical components, AC contactors, circuit br
